http://iscoresports.com/

Ok...so I messed up the staring lineup by forgetting to set a 10th batter to "No" for batting prior to game start.

No big issue...I've done it before!

Unfortunately, I didn't catch it until that player position had already batted and was on base. When I discovered the error, I went to Misc. - starting lineup and set that player as "No" for bating. In the past, that's usually all I had to do and iScore would fix the rest.

However, this time it didn't correct it. Now it just has that batters activity in the 10th batter spot, with no batter listed in the left colum. The rest of the game was off by one batter because of this.

If tried everything, from restarting the iPad, to deleting the player that I had accidentally put as a batter from that lineup.

Any suggestions. Don't want to have to manually enter the game again!

Thanks,

Once you bat that player, you cannot correct. Only choice is to undo at that point. If you catch before 10th batter then misc->show starting lineup will work. Once you bat around, iScore has locked in that many spots on the scorecard.

Suggest reentering game. Print up the play by play. Should take about 15 mins.